|
[Sponsors] |
May 14, 2007, 10:50 |
Rotating boundary
|
#1 |
Guest
Posts: n/a
|
Hello! I've to carry out a calculation in which a rotating boundary is present.The boundary moves into the fluid domain at a constant angular velocity.I set up an unsteady calculation in which boundary rotation around x axis is defined with a CEL like this:
omega = 890 [rad s^-1] alfa=omega * t sy = ((y*cos(alfa))-(z*sin(alfa)))-y sz = ((y*sin(alfa))-(z*cos(alfa)))-z CFX solver gives me always the same error, that is: "A negative element volume has been detected..." Time step is very small (about 10^-5). I tried different meshes and different definitions for mesh stiffness but I obtained always the same result. Thank you for collaboration, bye! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set rotating boundary? | conan | FLUENT | 2 | April 6, 2012 00:22 |
rotating wall boundary condition in multiphase | sdp | FLUENT | 0 | February 16, 2009 21:12 |
Boundary conditions for rotating fan | rohit | FLUENT | 5 | July 24, 2008 00:26 |
how to move a rotating boundary | zyf | FLUENT | 1 | December 3, 2007 02:49 |
Solver error message!!! | IoSa | CFX | 1 | September 14, 2006 04:48 |