|
[Sponsors] |
May 15, 2007, 16:58 |
ICEM HEXA - Match Edge Spacing
|
#1 |
Guest
Posts: n/a
|
Can someone please tell me how do you use this feature? I assume it is to match up the spacing on two edges, but whenever I try it it says the edges don't match
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
Spacing value in ICEM CFD | avi031 | ANSYS Meshing & Geometry | 5 | July 22, 2013 13:47 |
gmsh2ToFoam | sarajags_89 | OpenFOAM | 0 | November 24, 2009 22:50 |
ICEM hexa mesh built with v10 deformed in v11 (degenerated edges) | cfxicem | ANSYS Meshing & Geometry | 1 | October 14, 2009 15:06 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |