|
[Sponsors] |
May 19, 2007, 02:24 |
How to find hole in mesh
|
#1 |
Guest
Posts: n/a
|
Dear friends When I mesh ICEM CFD It shows some hole How I can detect the holes in gometry. How I can repair hole in mesh also I tried hole repair but it not give what are the element in hole.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] FluentMeshToFoam Cannot find a single face in the mesh which uses vertices | francesco_b | OpenFOAM Meshing & Mesh Conversion | 8 | December 2, 2020 02:57 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
mesh around suction hole | morteza08 | ANSYS Meshing & Geometry | 0 | August 18, 2010 07:48 |
Mesh for 3 dim Geometry | Phil | FLUENT | 9 | July 12, 2000 04:39 |
unstructured vs. structured grids | Frank Muldoon | Main CFD Forum | 1 | January 5, 1999 10:09 |