|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
ENIMA
Join Date: Jul 2021
Posts: 13
Rep Power: 5 ![]() |
hi
can any one can fixe the problem that i had in cfx Pre it's an error when i have tried to import ICEM CFD Mesh the error paragraph is in the figure attached all sugestions are welcome |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,781
Rep Power: 143 ![]() ![]() ![]() ![]() |
The error message is very clear - the file does not exist. I would have thought that makes it pretty obvious.
__________________
Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum. |
|
![]() |
![]() |
![]() |
![]() |
#3 |
New Member
Join Date: Nov 2017
Posts: 22
Rep Power: 8 ![]() |
Try to move your mesh.cfx5 file to root directory D:\
|
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Unable to import the requested mesh | ENIMAB | CFX | 6 | June 27, 2022 06:20 |
[PyFoam] Using pyFoamPlotWatcher.py To Plot Residuals | m_ridzon | OpenFOAM Community Contributions | 22 | January 26, 2021 18:48 |
I developed an FEM toolkit in Java: FuturEye | nkliuyueming | Main CFD Forum | 7 | January 29, 2016 13:28 |
[OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12 | keepfit | ParaView | 60 | September 18, 2013 03:23 |
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 20:30 |