 |
 |
 |
|
|
|
[Sponsors] | ||||
September 22, 2022, 03:33
|
hollow fiber membrane boundary setting
|
#1 |
|
New Member
sunny
Join Date: Sep 2022
Posts: 8
Rep Power: 3  |
hello everyone,
Assuming that oxygen flows inside the fiber, i want to set it up so that oxygen diffuses from the membrane. I want to specify the diffusion coefficient after setting the hollow fiber as a wall, is this possible with CFX? If there is another way, please let me know. How to set the boundary of the hollow fiber? Would be grateful for any help.  
|
|
|
|
|
|
September 22, 2022, 03:42
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
The image was not attached. Please post an image of what you are modelling and your output file.
__________________
Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum. |
|
|
|
|
|
|
September 22, 2022, 03:56
|
|
#3 |
|
New Member
sunny
Join Date: Sep 2022
Posts: 8
Rep Power: 3 |
I've added additional content along with the photo attachment.
thank you |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Table bounds warnings at: END OF TIME STEP | CFXer | CFX | 4 | July 16, 2020 23:44 |
| Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
| Question about adaptive timestepping | Guille1811 | CFX | 25 | November 12, 2017 17:38 |
| Problem in setting Boundary Condition | Madhatter92 | CFX | 12 | January 12, 2016 04:39 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Linear Mode
