|
[Sponsors] |
September 24, 2007, 12:27 |
Meshing tool discussion
|
#1 |
Guest
Posts: n/a
|
Hi, everyone,
Recently, I tried ANSYS Meshing inside WB11. I do not think the extra meshing methods (other than CFX-Mesh) are useful for CFD purpose. How do you think? For Tetra mesh, CFX-Mesh and ICEM CFD Basic both can do the work. Question is which one is better. I prefer CFX-Mesh just because it is simple to use and cheap for license. From my experience, the mesh generated by ICEM Basic might not be better than CFX-Mesh, although ICEM is more powerful. For Hexa mesh, ICEM CFD Hexa is the choice. Does ICEM Hexa have to work with ICEM Basic together? Can the combination of CFX-Mesh (for tetra mesh) and ICEM CFD Hexa (for hexa mesh) work well for meshing? Thanks. Please add your comments. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to make appear edge/line body (created in design modeler) in the meshing tool | Rockda | ANSYS Meshing & Geometry | 6 | June 8, 2016 23:10 |
[Other] CastNet: modeling and meshing tool for OpenFOAM | ulli | OpenFOAM Meshing & Mesh Conversion | 7 | May 31, 2011 01:14 |
[Other] Can anyone recommend a decent meshing tool ? | Marineboy | OpenFOAM Meshing & Mesh Conversion | 4 | August 30, 2010 17:49 |
[snappyHexMesh] MEshing Tool mentioned in the Milan Workshop | bastil | OpenFOAM Meshing & Mesh Conversion | 4 | August 1, 2008 03:49 |
[Other] Meshing tool for FV with Foam | frederic | OpenFOAM Meshing & Mesh Conversion | 1 | December 6, 2005 03:32 |