Solver message of fluid flowing out of domain

KM

Hi there,

Sometimes I get the following message during my simulations. A few times it used to disappear with iterations but now it keeps coming with every iteration.

Will it affect my results? How can I get rid of it? Thanks a ton in advance !!!!

Best Regards, Kushagra Mittal.

*************************Message*************

A wall has been placed at portion(s) of an INLET boundary condition (at 40.4% of the faces, 40.4% of the area) to prevent fluid from flowing out of the domain. The boundary condition name is: inlet. The fluid name is: Water. If this situation persists, consider switching to an Opening type boundary condition instead.