|
[Sponsors] |
HELP Beginner ICEM initialize PRE-MESH parameters |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 17, 2007, 15:06 |
HELP Beginner ICEM initialize PRE-MESH parameters
|
#1 |
Guest
Posts: n/a
|
Hello, how to initialize ALL pre-mesh settings: what i did is to set values for Edges and LATER for associated curves and LATER for Mesh by BLock Parts. How to initialize ALL values? Thank you
|
|
October 18, 2007, 01:23 |
Re: HELP Beginner ICEM initialize PRE-MESH paramet
|
#2 |
Guest
Posts: n/a
|
In ICEM-Hexa, you only need to set mesh parameters on edges of blocks. No need to set parameters of curves of geometry.
What 'initialization' are you talking about? Chirag |
|
October 18, 2007, 07:18 |
Re: HELP Beginner ICEM initialize PRE-MESH paramet
|
#3 |
Guest
Posts: n/a
|
i meant that ICEM does not set any values which i might have entered. The problem seems to be solved through setting Multigrid to 0 and entering the mesh law. However now i am fighting with the pre-mesh (Hexa) for the 2D-car. I want to run a simulation in CFX and the mesh in the tutorial is not good for it at all so i am doing it on my own and encountering messages like degenerate edge found. Am fighting
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Export 2D mesh from ICEM to Fluent | BuilttoSpill | ANSYS Meshing & Geometry | 4 | August 28, 2010 09:16 |
icem hexa mesh beginner | icem beginner | CFX | 3 | July 23, 2008 05:26 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 12:55 |
How to corse mesh in icem cfd? | Priety | CFX | 2 | October 2, 2006 04:57 |
CFX mesh & ICEM | mike | CFX | 3 | April 27, 2006 16:27 |