CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > CFX

boundary conditions for boundary layer flow

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   November 3, 2007, 08:11
Default boundary conditions for boundary layer flow
  #1
A. Al-zoubi
Guest
 
Posts: n/a
Hallo All,

I have done a simple simulation test to check the boundary conditions in ANSYS CFX11. I run the case of flow over a flat plate. I set opening in the free stream boundary condition. I got a surprising overshoot in the velocity field across the plate, i.e., the velocity in the boundary layer increases to a value higher than the free stream one then fall down to the free stream one. I have repeated the same simulation with setting a pressure BC instead of the opening but there was no difference.

I have used very fine mesh to check the grid convergence and also I have run it for laminar flow without success.

Have any one explanation for that.... Any hint is welcome.

Regards

A. Al-Zoubi
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Domain Imbalance HMR CFX 5 October 10, 2016 06:57
Water subcooled boiling Attesz CFX 7 January 5, 2013 04:32
To thin boundary layer? Luk CFX 3 February 27, 2009 04:22
Boundary conditions for turbulent boundary layer Thomas FLUENT 1 June 17, 2008 06:14
Boundary Conditions for Incompressible Flow Bob FLUENT 0 April 7, 2006 22:28


All times are GMT -4. The time now is 02:05.