|
[Sponsors] |
November 8, 2007, 05:22 |
distortion of mesh while loading the report
|
#1 |
Guest
Posts: n/a
|
When loading the results in the cfx-post a message box appears: an appropriate report template was found for this case. Turbine rotor report. Load y/n? I choose yes, but while loading, it distorts the mesh and all the reports end up wrong. To be exact the polyline at the 20% and 80% span is not constant but it looks more like a sin(x) plot. I don't know what is causing it and what is affected by it! How can I fix that?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
[GAMBIT] Face Mesh distortion | Forrest | ANSYS Meshing & Geometry | 0 | June 9, 2009 11:50 |
cfx mesh loading problem | u k jha | CFX | 3 | April 29, 2009 12:41 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
basic of mesh refinement | arya | CFX | 4 | June 19, 2007 12:21 |