CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > CFX

about FSI and Joins

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   December 5, 2007, 07:55
Default about FSI and Joins
  #1
kantoned
Guest
 
Posts: n/a
hello

i am trying to simulate a 2 way FSI on cfx and ansys design space , the solid part is a propeler that has 3 wings and the fluid is air at the speed of 2 m/sec,

the problem that i have is that in the ansys i put as joint a body to ground joint to the axis of the propeler. when i run the fsi simulation the ansys design space get me an error that the joint is not working. so i though to do only the stuctural to see why it is not working, the problem is on the joint of the propeller shaft to the ground, i first put a joint to ground but it was not working,,,, then i put a cyllidricaly support... the same error

can anyone tell me what i shall put to the shaft so it would rotate but not move ????

best regards kanton eddy

  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On



All times are GMT -4. The time now is 00:42.