Home > Forums > Software User Forums > ANSYS > CFX

how to change blade leading angle of axial turbine

Mark Forums Read

Reply

Search this Thread

June 2, 2008, 03:45	how to change blade leading angle of axial turbine	#1
dia aisa Guest Posts: n/a	dear all hello, i working in axial flow turbine,please how can i change the blade leading angle in blade -modeler that i using CFX.10,also what appropiate B.C for the case of 40m head and 116 meter cube of flow rate,also what can i check the mesh quility thanks

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
please help in simulating a wind turbine blade in 6 DOF ????....	usman naseer	Main CFD Forum	2	March 10, 2016 03:53
CFD analysis on wind turbine rotor	Ken (Wind Turbine CFD Super Rookie)	Main CFD Forum	45	February 9, 2016 15:07
[GAMBIT] Blade Turbine	Reza_computational	ANSYS Meshing & Geometry	0	July 7, 2011 07:09
Wind Turbine Blade Geometry	SeanieB	Main CFD Forum	0	November 27, 2009 11:18
2 stage axial turbine model convergence issues	sherifkadry	CFX	2	September 7, 2009 21:51

All times are GMT -4. The time now is 21:43.