Home > Forums > Software User Forums > ANSYS > CFX

pressure is not rising in compression stroke..

Mark Forums Read

Reply

Search this Thread

June 17, 2008, 03:13	pressure is not rising in compression stroke..	#1
chetan Guest Posts: n/a	i'm simulating the compression stroke of ic engine in CFX 11. at the end of suction stroke the mass in the cylinder was around 11 mg. but i'm getting pressure only 22 bar at the end of compression stroke. experimentaly it is around 32 bar. in CFX 10 for the same case it came around 36 bar. why the pressure is not rising in CFX 11???

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Calculation of the Governing Equations	Mihail	CFX	7	September 7, 2014 06:27
pressure BC-natural convection	engahmed	Main CFD Forum	0	June 16, 2010 11:38
Pressure rising with temperature	Koranten	FLUENT	0	August 19, 2009 05:57
Setting pressure and velocity in inlet	Asghari	FLUENT	5	September 22, 2006 13:23
compression stroke in piston engine	Hassaneen	Siemens	12	December 29, 2000 12:30

All times are GMT -4. The time now is 13:27.