|
[Sponsors] |
ansys 11--icemcfd mesh or workbench mesh better |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 30, 2008, 01:31 |
ansys 11--icemcfd mesh or workbench mesh better
|
#1 |
Guest
Posts: n/a
|
Hi
could anyone plz suggest me the regarding the mesh among icem cfd and workbench mesh--- which would converge better and help in plotting good results. if it effects in values of results?? For buoyant case which one will be the most suitable one?? Thanks in advance |
|
June 30, 2008, 09:39 |
Re: ansys 11--icemcfd mesh or workbench mesh bette
|
#2 |
Guest
Posts: n/a
|
I have not used the work bench and not seen as how it produces the mesh, but i can tell you that for convergence you require a good mesh thats all, irrespective of whether mesh is from workbench or icemcfd.
I would have gone for icemcfd because i guess you have more control over the mesh in icemcfd |
|
June 30, 2008, 20:35 |
Re: ansys 11--icemcfd mesh or workbench mesh bette
|
#3 |
Guest
Posts: n/a
|
hexahedrical or thetra brings the same results, BUT, hexahedrical mesh spend less effort computational and it has a quick convergence!
|
|
July 11, 2008, 06:43 |
Re: ansys 11--icemcfd mesh or workbench mesh bette
|
#4 |
Guest
Posts: n/a
|
I am learning Ansys ICEMCFX by my own, i am facing difficulty in exporting mesh file to the CFXPre. Would you please tell me the procedure in detail. I an a student of Indian Institute of Technology,Kharagpur, India. I have a project on Two phase flow. i have prepared geometry after that what shoud i do, i am confused so Please reply soon. thank you.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mesh motion with Translation & Rotation | Doginal | CFX | 2 | January 12, 2014 06:21 |
Exporting structured mesh from ICEMCFD to Fluent? | jeevan kumar | FLUENT | 1 | January 23, 2012 11:21 |
mesh in ansys workbench | swe704 | ANSYS Meshing & Geometry | 1 | May 15, 2011 12:20 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
2D mesh in ANSYS 10.0 Workbench | Frank Peters | CFX | 4 | May 18, 2006 04:36 |