|
[Sponsors] |
September 11, 2008, 16:47 |
From mesh to geometry
|
#1 |
Guest
Posts: n/a
|
Hallo to anyone. Does anyone know if it is possble to create a geometry and a blocking from one mesh file? I try to explain myself, before someone thinks I am drunk: I have one definition file from cfx and i wanna change some details in the geometry, but I manage only to see the mesh in icem, and not to work about it. And time is never enough to make all from the start...
Thank you in advance. |
|
September 11, 2008, 18:43 |
Re: From mesh to geometry
|
#2 |
Guest
Posts: n/a
|
Hi,
You can use the mesh editing functions in ICEM to change a mesh. Not sure whether you can change the blocking, I doubt it. Glenn Horrocks |
|
September 12, 2008, 01:18 |
Re: From mesh to geometry
|
#3 |
Guest
Posts: n/a
|
Laura,
You can not change Blocking in mesh , But one thing what you can do is , You can export facets to geometry and them modify there only. |
|
September 12, 2008, 11:33 |
Re: From mesh to geometry
|
#4 |
Guest
Posts: n/a
|
Assuming it is a block-structured mesh (not tets or a swept quad-paved mesh) - you can extract a blocking. Load the UNS file (block-structured mesh). File > Blocking > Load from Unstructured Mesh will extract a blocking file with node counts - but not distributions. Then you can modify the blocking. You can also do Edit > Mesh to Facets to extract a faceted geometry from the mesh.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
Inflation Mesh Possible with Multizone Method for this Geometry | jonny_b | ANSYS Meshing & Geometry | 2 | September 16, 2011 16:20 |
[snappyHexMesh] Mesh a geometry without stl file | eysteinn | OpenFOAM Meshing & Mesh Conversion | 0 | May 5, 2011 10:15 |
[snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |