|
[Sponsors] |
September 13, 2008, 01:32 |
ICEM
|
#1 |
Guest
Posts: n/a
|
ALL, WHAT IS MEANT BY RUNNING CUTTER,THIS MESSAGE I SAW WHEN EVER A RUNNING AT ICEM AT THE MIDDLE OF RUNNING SHOWING.
|
|
September 13, 2008, 17:04 |
Re: ICEM
|
#2 |
Guest
Posts: n/a
|
Your caps lock key is stuck on.
When ICEM builds a mesh (using Octree) it starts with one element in the middle and grows the elements until they hit the surfaces. The cutter then cuts every element that intersects a surface. The portions of the cut elements that are outside of the domain are then discarded. |
|
September 13, 2008, 23:32 |
Re: ICEM
|
#3 |
Guest
Posts: n/a
|
mr.johnny, ok,my geometry size:diameter 800mm thickness:2mm,in that i will give tetra mesh i given already,in that running cutter is showing i am thinking i given input parameter wrongs(mesh element size) in that geometry how to give mesh element size,any standared is there,please help me. thankyou.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PEM Fuel cell module meshes. ICEM vs workbench | aarvay | FLUENT | 24 | March 2, 2020 06:50 |
[ANSYS Meshing] Workbench 13: Structured Hexa Meshes | rooftop | ANSYS Meshing & Geometry | 19 | March 31, 2016 02:33 |
Design Modeler to ICEM..... | Joe | CFX | 0 | January 24, 2008 03:39 |
ICEM 10 mesh scale foe CFX | Korsh Mik | CFX | 2 | October 7, 2005 09:07 |
ICEM CFD 5.1 Hex-Tet mesh merging failure | bogesz | CFX | 1 | January 29, 2005 06:46 |