|
[Sponsors] |
December 14, 2008, 13:59 |
Local meshing
|
#1 |
Guest
Posts: n/a
|
Hi, I am a new user of ANSYS CFX. I am currently wokring on a air-flow through combustor project.
In ANSYS CFX, how could I do a very fine local meshing in the area taht I want ? By the way, if the results do not converge after running, what should I do to improve that? Best of regards Eric |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 02:58 |
Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 18:07 |