|
[Sponsors] |
January 23, 2009, 02:58 |
how to create contour surface for some range
|
#1 |
Guest
Posts: n/a
|
Dear CFX users
I want to plot the range of mach no from 1 to 1.6 in the fluid domain, my question is that " how to create the surface for specified range of variable i.e mach no from 1 to 1.6" In fluet it is easy. just we use the clip range command. I m stuck in this problem Any help will be highly appreciated. Best Regards SA |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Contour Plot of a curved surface projected onto a flat plane | Amp | CFX | 4 | March 12, 2013 22:54 |
Wont let me create a surface from a sketch | chay89 | FLUENT | 0 | April 28, 2011 17:04 |
[snappyHexMesh] How to create a separate patch on a blockmesh surface | bing.guo | OpenFOAM Meshing & Mesh Conversion | 0 | April 24, 2011 11:35 |
solid edge problem....can you help? | cindy | Main CFD Forum | 3 | April 5, 2004 13:43 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |