 |
 |
 |
|
|
|
[Sponsors] | ||||
May 6, 2010, 11:40
|
Restart Problem CFX.12
|
#1 |
|
New Member
Juan
Join Date: Feb 2010
Location: Spain
Posts: 5
Rep Power: 16  |
Hello,
I have to stop a simulation because there's gonna be a power cut where I work. So I was looking for the way of doing a restart. I found out that it's possible and I tested, and when I wanted to review the results in CFD Post I found out that there are no results before the moment I've restarted my simulation, after this moment there is no problem with the results. What could I do? I'm new with this program and I donīt Know too much. Thanks in advance. Last edited by juansan; May 6, 2010 at 12:44. |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
| Incoherent problem table in hollow-fiber spinning | Gianni | FLUENT | 0 | April 5, 2008 10:33 |
| natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
| Backup & Restart problem | Sally | CFX | 4 | November 19, 2005 12:44 |
Threaded Mode
