|
[Sponsors] |
October 13, 2009, 11:19 |
Negative value of additional variable
|
#1 |
New Member
Joe
Join Date: Mar 2009
Posts: 7
Rep Power: 17 |
Hi All,
I've got a question about the additional variable in CFX 11.0. It's a transient calculation with additional variable set to simulate tracer gas. The additional variable type is 'specific' with a value of 1 at one inlet and 0 at another inlet. When doing contour plots in the post-processing, I found it has a global range of -0.09 to 1.04, which is physicallly unrealistic. Has anyone got a clue on this? Thanks in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
Problems with additional variable | Krishna Premi | CFX | 1 | October 29, 2007 08:19 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
Multi_component Vs Additional Variable | Anurag | CFX | 2 | February 4, 2005 16:45 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |