|
[Sponsors] |
July 29, 2010, 03:45 |
high pressure ratio
|
#1 |
Senior Member
Join Date: Jul 2010
Posts: 152
Rep Power: 15 |
hello, I have a problem with centrifugal compressor boundary conditions setting. I have to check 4 points on compressor characteristics and I have already set boundary conditions for 3 points and I got reasonable results from all of them. But the same settings for point with highest pressure ratio and mass flow doesn't provide results with the same deviation. Please, does anybody have an advice??
Last edited by keeper; July 29, 2010 at 04:21. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pressure BC for combustion chamber | Giuki | FLUENT | 1 | July 19, 2011 11:35 |
interFoam: strange pressure with high fluid viscosity? | ckroener | OpenFOAM | 3 | April 7, 2010 12:51 |
pressure ratio simpleFoam boundary case/0/p | Hasselhoff | OpenFOAM | 2 | June 29, 2009 18:43 |
Hydrostatic pressure in 2-phase flow modeling (CFX4.2) | HB &DS | CFX | 0 | January 9, 2000 13:19 |
Hydrostatic pressure in 2-phase flow modeling (long) | DS & HB | Main CFD Forum | 0 | January 8, 2000 15:00 |