|
[Sponsors] |
November 18, 2010, 12:16 |
Multiphase settings - Interface Compression
|
#1 |
New Member
Willian
Join Date: Jan 2010
Location: Brasil
Posts: 22
Rep Power: 16 |
Hi everyone,
I´m working on a multiphase problem on CFX and I've noticed that there is an option to use "interface compression (default value=2)" for free surface problems. There isn't such information on CFX manual, even a citation. I've also looked for in forum, but apparently anyone knows too. Does anyone know what this option does on fluids interface? I´ll be glad if anyone explain this for me, Willian |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
VOF interface compression and mesh size | idrama | OpenFOAM | 1 | September 26, 2010 06:36 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |