|
[Sponsors] |
January 10, 2011, 03:21 |
Inflation problem
|
#1 |
Member
Derwin Parkin
Join Date: Feb 2010
Posts: 35
Rep Power: 16 |
Hello...I'll keep this short. Any ideas on how to extend this inflation all the way to that corner (see attached picture)? In this case I have two separate regions meeting right where I want the inflation to stop. NOTE: the regions are part of the same "part" in the geometry module.
I'm using Workbench 12.1...any help would be greatly appreciated! |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Incoherent problem table in hollow-fiber spinning | Gianni | FLUENT | 0 | April 5, 2008 10:33 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Inflation | Gab | CFX | 6 | August 24, 2005 22:45 |
inflation | Jennifer Haque | CFX | 2 | June 9, 2004 18:55 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |