|
[Sponsors] |
September 28, 2013, 13:18 |
error in 3 blade axial pump
|
#1 |
Member
Mohamad Alagheband
Join Date: Oct 2012
Posts: 41
Rep Power: 13 |
hi,
I'm trying to simulate an axial blood pump with three blade . volumetric mass flow trend at the outlet doesn't fit with my expectation while RMS goes to convergence it's steady state simulation adequate inlet and outlet domain |
|
September 30, 2013, 18:36 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
A general question gets a general answer: http://www.cfd-online.com/Wiki/Ansys..._inaccurate.3F
|
|
October 1, 2013, 12:37 |
|
#3 | |
Member
Mohamad Alagheband
Join Date: Oct 2012
Posts: 41
Rep Power: 13 |
Quote:
thanks for respond i found out thesolution and that was not general. thanks |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Axial Flow Pump Performance Prediction | bharathn | CFX | 1 | February 25, 2013 17:51 |
[DesignModeler] blade gen for axial compressor | eslamnagy | ANSYS Meshing & Geometry | 0 | January 13, 2013 09:22 |
[GAMBIT] influence between angle in impeller blade and centrifugal pump performance | barak182 | ANSYS Meshing & Geometry | 2 | August 18, 2010 03:07 |
axial flow pump, inflow boundary | tma | CFX | 3 | September 26, 2002 15:28 |