CEL problem -- CFD Online Discussion Forums

May 1, 2011, 16:45	CEL problem	#1
juliom Senior Member Julio Mendez Join Date: Apr 2009 Location: Fairburn, GA. USA Posts: 290 Rep Power: 18	Hello my dear collegues. I have been working on an oil and gas separator, but I have not had any result of my CFX. I do no know where are my mistakes here I let you some information about it: Boundaries conditions Inlet: mass flow rate of each phase Multiphase model: mixture Outlet: upper outlet: opening bottom outle: opening The other problem is that I defined some CEL, at the outlet I defined: massflow()@outlet. but it gave a straight line in the output file.. It seems that the program is not computing any flow mass at taht opening.. SOME SUGGESTIONS?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
UDF compiling problem	Wouter	Fluent UDF and Scheme Programming	6	June 6, 2012 04:43
Incoherent problem table in hollow-fiber spinning	Gianni	FLUENT	0	April 5, 2008 10:33
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 19:13
Problem in Tutorial problem of fluent	Phanindra	FLUENT	5	April 17, 2007 09:57
Is this problem well posed?	Thomas P. Abraham	Main CFD Forum	5	September 8, 1999 14:52

All times are GMT -4. The time now is 15:40.