|
[Sponsors] |
June 3, 2011, 03:12 |
Over constrained Boundary Conditions
|
#1 |
Senior Member
---------
Join Date: Oct 2010
Posts: 303
Rep Power: 17 |
Can some one please tell me if it is a over constrained approach to specify both volumetric flow rate and pressure on a inlet boundary
__________________
Best regards, Santhosh. |
|
June 3, 2011, 05:13 |
|
#2 |
New Member
Redddy
Join Date: Sep 2010
Posts: 25
Rep Power: 15 |
yes, absolutely it is over constrained approach. moreover, its not possible to given two boundary conditions at one side.
May i know where you want to use? |
|
June 3, 2011, 07:57 |
|
#3 |
Senior Member
---------
Join Date: Oct 2010
Posts: 303
Rep Power: 17 |
Hi,
Can you please tell me how to calculate pressure over the inlet given the volume flow rate and the fluid used being Air
__________________
Best regards, Santhosh. |
|
June 3, 2011, 11:15 |
|
#4 |
New Member
Redddy
Join Date: Sep 2010
Posts: 25
Rep Power: 15 |
you can calculate velocity for given flow rate. then calculate total pressure over surface by using static pressure plus dynamic pressure.
Still, u had not in circle, describe your problem in detail.. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Impinging Jet Boundary Conditions | Anindya | Main CFD Forum | 25 | February 27, 2016 12:58 |
symmetry boundary conditions in cfx | lost.identity | CFX | 41 | May 22, 2013 07:21 |
OpenFOAM Variable Velocity Boundary Conditions | NickolasPl | OpenFOAM Programming & Development | 2 | May 19, 2011 05:37 |
[Netgen] boundary conditions and mesh exporting | vaina74 | OpenFOAM Meshing & Mesh Conversion | 2 | May 27, 2010 09:38 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |