|
[Sponsors] |
October 3, 2011, 09:21 |
NACA airfoil with LES
|
#1 |
Senior Member
Roland Rakos
Join Date: Mar 2009
Posts: 131
Rep Power: 17 |
Hello,
I would like to investigate an NACA airfoil with LES. My computer capacity is not too large and I have to calculate a lot of cases. Therefore I would like to study 2D cases only. I know that the 2D simulation is not too correct in case of LES but at the moment there is not other possibility. So if I apply the LES then my result is total bad or it will contain fewer information than in case of 3D ? Thanks Roland |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Lift and Drag Coefficient data for NACA 2412 Airfoil | mahbub03 | Main CFD Forum | 22 | May 25, 2014 15:39 |
[mesh tool] meshing airfoil naca 0015 | peter pan | ANSYS Meshing & Geometry | 0 | June 15, 2011 09:26 |
Symmetric NACA Airfoil Lift and Drag Data | jrider22 | Main CFD Forum | 3 | April 15, 2010 04:59 |
Airfoil sim using LES | Andrew | FLUENT | 0 | January 20, 2009 20:47 |
Drag prediction for Naca 23012 airfoil | Ravel Bogatec | CFX | 17 | February 15, 2008 00:21 |