What mean by "preset species data' and 'outflow' settings in plasma model

tomchiah · November 21, 2023, 12:09

Hi all, I tried look around to find out what these two settings means, but unfortunately, I could not find any. Did anyone know what means by these 2 as shown in the picture attached? These are species settings under plasma model
Screenshot 2023-11-22 010342.jpg

aminem · December 26, 2023, 06:29

I't to fill parameters (molar mass, Potential characteristic lenght, ...) bu the value existing in COMSOL library.

tomchiah · December 26, 2023, 08:05

In this case, how do i know which species to set with respectively?

aminem · December 27, 2023, 02:26

It's depending of the species you ar setting. For Ar+ you can put Ar. If the species not existing in COMSOL data base you should put all parameter manually.

tomchiah · December 27, 2023, 08:14

Yes, this is referring to preset species data. But how about outflow, inflow, symmetry and flux settings?

November 21, 2023, 12:09	What mean by "preset species data' and 'outflow' settings in plasma model	#1
tomchiah Member Chiah Zi Jing Join Date: Oct 2023 Location: Xiamen University Malaysia (XMUM) Sepang, Malaysia Posts: 38 Rep Power: 2	Hi all, I tried look around to find out what these two settings means, but unfortunately, I could not find any. Did anyone know what means by these 2 as shown in the picture attached? These are species settings under plasma model Screenshot 2023-11-22 010342.jpg

December 26, 2023, 06:29		#2
aminem Member amine Join Date: Jan 2014 Location: FRANCE Posts: 84 Rep Power: 12	I't to fill parameters (molar mass, Potential characteristic lenght, ...) bu the value existing in COMSOL library. tomchiah likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
outflow data	love T-mac	FLUENT	0	May 21, 2005 12:13

December 26, 2023, 08:05		#3
tomchiah Member Chiah Zi Jing Join Date: Oct 2023 Location: Xiamen University Malaysia (XMUM) Sepang, Malaysia Posts: 38 Rep Power: 2	In this case, how do i know which species to set with respectively?

December 27, 2023, 02:26		#4
aminem Member amine Join Date: Jan 2014 Location: FRANCE Posts: 84 Rep Power: 12	It's depending of the species you ar setting. For Ar+ you can put Ar. If the species not existing in COMSOL data base you should put all parameter manually.

December 27, 2023, 08:14		#5
tomchiah Member Chiah Zi Jing Join Date: Oct 2023 Location: Xiamen University Malaysia (XMUM) Sepang, Malaysia Posts: 38 Rep Power: 2	Yes, this is referring to preset species data. But how about outflow, inflow, symmetry and flux settings?