|
[Sponsors] |
November 4, 2016, 17:28 |
Problems with mech.dat in Converge 2.3.16
|
#1 |
New Member
Join Date: Oct 2016
Posts: 6
Rep Power: 9 |
Hi everyone,
I had some cases running succesfully on Converge 2.3.10, involving combustion reactions. Then I updated Converge to the 2.3.16 version and tried to run the same cases, but I've had some problems: 1) if I include the mech.dat, but not the species.in file (which worked with Converge 2.3.10), I get the following error *** Process received signal *** Signal: Segmentation fault (11) Signal code: Address not mapped (1) Failing at address: (nil) [ 0] /lib64/libpthread.so.0() [0x3da6a0f710] [ 1] converge-2.3.16-openmpi(write_check_mech+0x108a) [0x7c68fa] [ 2] converge-2.3.16-openmpi(setup+0x7545) [0x71e835] [ 3] converge-2.3.16-openmpi(main+0x1e2) [0x638d12] [ 4] /lib64/libc.so.6(__libc_start_main+0xfd) [0x3da621ed5d] [ 5] converge-2.3.16-openmpi(realloc+0x229) [0x4a2a19] *** End of error message *** 2) if I include the species.in file, but not the mech.dat, the simulation starts without problems but, of course, no reactions take place 3) if I include both mech.dat and species.in, I get the following error JOB ABORT invoked by rank 0: ERROR: there is no thermodynamic data for species O2 Have you got any idea of what the problem could be? I'm rather sure that it is a bug, because as I said before I had no problems with the 2.3.10 version. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Needed Benchmark Problems for FSI | Mechstud | Main CFD Forum | 4 | July 26, 2011 12:13 |
HELP !In relaxtion factor converge is taken or not | MANOJ KUMAR | FLUENT | 5 | September 22, 2005 04:16 |
Converge problem for multiphase flow | Jen | FLUENT | 4 | July 20, 2005 16:52 |
Some problems with Star CD | Micha | Siemens | 0 | August 6, 2003 13:55 |
unstructured grid | sreekanth | Main CFD Forum | 1 | August 6, 2001 15:09 |