 |
 |
 |
|
|
|
[Sponsors] | ||||
May 15, 2017, 10:48
|
How set wall values
|
#1 |
|
New Member
Join Date: Dec 2016
Posts: 13
Rep Power: 9  |
Hi! I need to set a CHT case with a coating on piston, but I can't use the contact resistance because it doesn't take in account the thermal capacitance and for the coating that we need to simulate the thermal capacitance have to be considered. Due to computational limitations I can't create the coating on the geometry, as I wouldl need a ultra very fine mesh.
I want to know if it's possible to introduce the thermal capacitance in the wall_values.in file? Best regards |
|
|
|
|
|
June 6, 2017, 12:21
|
|
#2 |
|
Senior Member
Sameera Wijeyakulasuriya
Join Date: Jan 2016
Location: Convergent Science, Madison WI
Posts: 117
Rep Power: 10 |
You can try using the CHT-1D feature to model this. We specify heat capacity (Cp) for a solid and hence thermal capacitance should be taken in to account. Contact support@convergecfd.com if you need help setting up your case with CHT-1D.
|
|
|
|
|
|
 |
| Tags |
| simulation, wall values |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Set wall wettability (contact angle) in Fluent | yulu | FLUENT | 4 | December 11, 2020 00:55 |
| How to use a UDF to set the volume fraction in the cells next to a wall? | DF15 | Fluent UDF and Scheme Programming | 33 | August 20, 2020 13:36 |
| Possible bug with stitchMesh and cyclics in OpenFoam | Jack001 | OpenFOAM Pre-Processing | 0 | May 21, 2016 08:00 |
| Difficulty In Setting Boundary Conditions | Moinul Haque | CFX | 4 | November 25, 2014 17:30 |
| Range of wall y+ values | rks171 | Main CFD Forum | 1 | January 4, 2012 16:54 |
Linear Mode
