|
[Sponsors] |
May 8, 2017, 01:22 |
questions on wall film simulation 2
|
#1 |
New Member
Join Date: Feb 2017
Posts: 5
Rep Power: 9 |
Dear Support,
I have another question on wall film simulation. We have 2 port designs, A and B, for a GDI engine. In experiments, A has higher soot PN (numner density) than B does. We expected A would also have more piston wall film than B does. But, in simulation, A has less piston wall film than B does. So my questions are 1. Suppose my logic is problematic, should it be expected that PN correlates with piston wall film, proportionally? 2. Suppose numerical results are wrong, which part shall I pay particular attention to in wall film simulation. I set up my simulation according to the tutorial SI8 case. Thanks a lot. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Some questions about flow boiling simulation in Fluent | beastieboys6 | FLUENT | 8 | November 20, 2017 23:47 |
Eulerian wall film (Mass convergence stabilized, film transport height varies!) | Jeeloong | FLUENT | 0 | February 11, 2016 20:37 |
Problem with an old Simulation | FrankW | CFX | 3 | February 8, 2016 04:28 |
simulation of wall with holes | bitacovir | CFX | 2 | October 24, 2013 06:54 |
UDF for wall slipping | HFLUENT | Fluent UDF and Scheme Programming | 0 | April 27, 2011 12:03 |