 |
 |
 |
|
|
|
[Sponsors] | ||||
April 23, 2019, 10:23
|
Cell type not recognised
|
#1 |
|
Member
Rajat soni
Join Date: Oct 2016
Posts: 32
Rep Power: 10  |
Hello everyone,
I am doing a simple simulation of an RCEM with a moving piston. The output files are too small (1 KB all) and during converting the files through post_convert utility, I am getting the following error: "ERROR, cell type 722438103 not recognized for cell 220156" does anyone know anything about it? Please ask if any further information is needed. Regards, Rajat |
|
|
|
|
|
April 23, 2019, 11:54
|
|
#2 |
|
Member
Rajat soni
Join Date: Oct 2016
Posts: 32
Rep Power: 10 |
Hi all,
I found the problem in my case setup. Apparently, I was running the simulation in serial while the "MPI write" option was checked (=1 in inputs.in) in the "output" settings. Cheers, Rajat |
|
|
|
|
|
 |
| Tags |
| cell type error, converge error, post file |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| High nut values in random place and time | krzychu111 | OpenFOAM Running, Solving & CFD | 0 | January 9, 2019 08:42 |
| Strange high velocity in centrifugal pump simulation | huangxianbei | OpenFOAM Running, Solving & CFD | 26 | August 15, 2014 02:27 |
| SimpleFoam - instable simulation | Specialist | OpenFOAM Running, Solving & CFD | 17 | August 12, 2014 04:52 |
| Error during initialization of "rhoSimpleFoam" | kornickel | OpenFOAM Running, Solving & CFD | 8 | September 17, 2013 05:37 |
| [GAMBIT] periodic faces not matching | Aadhavan | ANSYS Meshing & Geometry | 6 | August 31, 2013 11:25 |
Linear Mode
