 |
 |
 |
|
|
|
[Sponsors] | ||||
A question about warning:flux scaling factor in film evap |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 8, 2020, 06:24
|
A question about warning:flux scaling factor in film evap
|
#1 |
|
New Member
HAORAN LI
Join Date: Mar 2020
Posts: 6
Rep Power: 6  |
Hello everyone,
I`m running my case(GDI engine) with CONVERGE2.3, the dt turn into dt_min(in my case, dt_min=1E-08) near to the end of injection, and there are many warnings like "flux scaling factor in film evap should be greater than 0 and less than 1.1, current value is -0.000850". After this, my case is still running but dt is so small that the running time will be unacceptable.Can anyone tell me how to fix it? Best regards! L.H.R. |
|
|
|
|
| Tags |
| converge, disi engine, gdi engine, simulation |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A question about horizontal film boiling tutorial? | Asghari | FLUENT | 3 | September 23, 2016 13:18 |
| Question abt the CFX tutorial regarding scaling of the rotor blade row! | MAP7 | CFX | 0 | April 24, 2014 05:46 |
| question about simulation of falling water film | mengyue1 | FLUENT | 2 | March 30, 2014 10:16 |
| Question about grid scaling... | Iaroslav | FLUENT | 3 | May 15, 2009 04:03 |
| Can 'shock waves' occur in viscous fluid flows? | diaw | Main CFD Forum | 104 | February 16, 2006 05:44 |
Threaded Mode
