|
[Sponsors] |
January 31, 2021, 22:06 |
'Tot_Inj_Mass' decrease
|
#1 |
New Member
liang11
Join Date: Nov 2020
Posts: 15
Rep Power: 5 |
Hello, everyone!
I am working on water direct injection on a SI engine. In one case, the water mass and injection duration are respectively set as 5.1 mg and 2.2 °CA. And the setup of the spray model is similar to GDI spray. However, the total injection mass decreases near the end of injection, even lower than the liquid spray mass. I don't know why? Besides, if the water mass and injection duration increase, the problem may not exist. I really appreciate your help! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tª increase when Pressure decrease in Ideal Gas :S | joseitor | CFX | 13 | January 12, 2016 17:22 |
buoyantPimpleFoam with thermalBaffle1D: strange temperature decrease | donQi | OpenFOAM Running, Solving & CFD | 0 | July 14, 2014 20:30 |
Unexpected deltaT decrease in pimpleFoam simulation | robyTKD | OpenFOAM Running, Solving & CFD | 9 | June 27, 2014 06:52 |
help,why the negative energy source does'nt make the temperature decrease, thank you! | hunter | FLUENT | 6 | May 12, 2010 17:39 |
decrease in residual order and it's influence | michel | Main CFD Forum | 2 | July 22, 2002 18:16 |