|
[Sponsors] |
October 27, 2023, 15:49 |
Plane Creation in Ensight
|
#1 |
New Member
Talha Ahmad
Join Date: Oct 2023
Posts: 2
Rep Power: 0 |
I'm relatively new to Ensight, and I'm currently doing post-processing with it. I'm stuck on a problem - I want to limit the plane to the central section while excluding the outer portion. Could someone kindly point me in the right direction by suggesting which tool or steps to use for achieving this specific task? (Picture Attached!)
|
|
Tags |
ensight vizualisation |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gmsh Structured mesh that crached in openFoam simulation | basma | OpenFOAM | 0 | August 2, 2022 14:39 |
OpenFOAM error | Vinay Kumar V | Main CFD Forum | 0 | February 20, 2020 09:17 |
Creation of a plane surface with the TUI | EmiS | FLUENT | 2 | August 31, 2016 08:11 |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
[Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |