Create domain in Hexpress by importing geometry from CATIA V5R21

PeiSan · June 29, 2014, 12:16

Hi,

Now i am trying to create a domain in numeca hexpress by importing file from CATIA V5 where initially the Maxsurf software was used to design my ship's hull. I have been tried by importing the model in CAT.part and .stl file type but both of it can't used to create domain after i create a box as a boundary for my ship's hull. In addition, hexpress keep shown that my geometry model has problem although in Catia it was in good condition. So, may i know how to solve this problem?

Thanks.

Rombzh · June 30, 2014, 05:10

Hi,

Can you export your file as a parasolid ? After importing the parasolid file in Hexpress, do right click on the part and do "check". It should tell you if there is an issue and maybe point what is causing a problem (it can be a corrupted geometry if there are overlapping surfaces for instance).
Also try to make sure your geometry is watertight.

June 29, 2014, 12:16	Create domain in Hexpress by importing geometry from CATIA V5R21	#1
PeiSan New Member Lim Pei San Join Date: Mar 2014 Posts: 25 Rep Power: 12	Hi, Now i am trying to create a domain in numeca hexpress by importing file from CATIA V5 where initially the Maxsurf software was used to design my ship's hull. I have been tried by importing the model in CAT.part and .stl file type but both of it can't used to create domain after i create a box as a boundary for my ship's hull. In addition, hexpress keep shown that my geometry model has problem although in Catia it was in good condition. So, may i know how to solve this problem? Thanks.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[GAMBIT] How to plot S pipe	mariam.sara	ANSYS Meshing & Geometry	36	November 7, 2013 16:22
Geometry basics. How do i model an open domain to simulate a jet flow	canev.civelek	ANSYS	7	March 12, 2012 06:26
importing geometry into starccm	krishna086	STAR-CCM+	0	November 28, 2010 22:54
Flow Domain Geometry	Giacomo Pavanelli	Main CFD Forum	0	November 21, 2010 19:55
block geometry inside fluid domain	jeff	Main CFD Forum	18	April 12, 2004 12:37

June 30, 2014, 05:10		#2
Rombzh Member Romain Join Date: May 2009 Posts: 40 Rep Power: 17	Hi, Can you export your file as a parasolid ? After importing the parasolid file in Hexpress, do right click on the part and do "check". It should tell you if there is an issue and maybe point what is causing a problem (it can be a corrupted geometry if there are overlapping surfaces for instance). Also try to make sure your geometry is watertight.