 |
 |
 |
|
|
|
[Sponsors] | ||||
May 15, 2016, 13:38
|
negative volumes
|
#1 |
|
New Member
farhad
Join Date: May 2016
Posts: 7
Rep Power: 11  |
hi . i have a problem with negative volume sin autogrid5. in double precision mesh there is no negative volumes but in single precision there are negative volumes . the problem is when i want to do optimization ,specially screening before it , i face an error about negative volumes , thanks for your care
Last edited by farhadkhari; May 15, 2016 at 15:48. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 18:22 |
| [blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 06:42 |
| [blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 10:56 |
| [blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 15:11 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 15:00 |
Linear Mode
