 |
 |
 |
|
|
|
[Sponsors] | ||||
the problem to generate grids for turbine in Numeca |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 29, 2018, 01:27
|
the problem to generate grids for turbine in Numeca
|
#1 |
|
New Member
Join Date: Oct 2018
Posts: 1
Rep Power: 0  |
hi,everyone,
when i use Numeca>Autogrid5 to generate grids for turbine, i meet the problem that "main blade: trailing edge does not intersect shroud", i find There is a gap between blade and shroud in fact, so, how can I extend the length of the blade to intersect shroud in Autogrid5 ？any advise? thank you very much! |
|
|
|
|
| Tags |
| autogrid5, grids, numeca |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Connectivity problem with grids created using gmsh | shank19 | SU2 | 3 | May 10, 2017 08:54 |
| Heat Transfert, mixing problem | Wazdq | CFX | 8 | November 7, 2016 05:44 |
| problem related to staggered grids | zhu | Main CFD Forum | 10 | October 27, 2001 22:30 |
| extremely simple problem... can you solve it properly? | Mikhail | Main CFD Forum | 40 | September 9, 1999 09:11 |
| unstructured vs. structured grids | Frank Muldoon | Main CFD Forum | 1 | January 5, 1999 10:09 |
Threaded Mode
