|
[Sponsors] |
December 16, 2015, 10:34 |
how to start with a parametic case study?
|
#1 |
New Member
Sascha
Join Date: Dec 2014
Posts: 9
Rep Power: 11 |
i would like to run a flow simulation. it is quite simple.
in coming with 6bar out coming to 1bar normal atmosphere pressure. and with water thats all. And in 2D. My question is how can I do 6 or 50 different simulations with different sketch parameters. Are there other ways then using the configs of the model? Best regard and thanks Sascha --- Solidworks Flow 2014 |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
WENO accuracy study, a 2D test case? | Faraz | Main CFD Forum | 12 | October 26, 2017 10:45 |
MRFSimpleFoam wind turbine case diverges | ysh1227 | OpenFOAM Running, Solving & CFD | 2 | May 7, 2015 10:13 |
How to Initialise my LES case using my RANS case is there any utility for it ? | Alhasan | OpenFOAM Running, Solving & CFD | 2 | May 10, 2014 00:14 |
Can't run a case in HelyxOS with an imported mesh from Fluent | HHOS | OpenFOAM Running, Solving & CFD | 0 | July 2, 2013 06:25 |
Aero study for symmetry case | Nevur | FLUENT | 2 | September 28, 2005 01:38 |