 |
 |
 |
|
|
|
[Sponsors] | ||||
March 17, 2016, 10:08
|
Multiple surface selction in FloEFD
|
#1 |
|
New Member
G.
Join Date: Mar 2016
Posts: 4
Rep Power: 10  |
Hi there,
I am trying to apply a surface source on die inner cavtity. Therefor I need to select quite a lot of little surfaces which are very hard to select by clicking each and every single on. Is there a way to select multiple surfaces via polygon or rectengular drag courser in the FloEFD selction window? Regards |
|
|
|
|
| Tags |
| surface seletion multiple |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
| [snappyHexMesh] Problem with Sanpper, surface still Rough | Zephiro88 | OpenFOAM Meshing & Mesh Conversion | 7 | November 5, 2014 12:05 |
| Cluster ID's not contiguous in compute-nodes domain. ??? | Shogan | FLUENT | 1 | May 28, 2014 15:03 |
| [snappyHexMesh] Layers don't fully surround surface | EVBUCF | OpenFOAM Meshing & Mesh Conversion | 14 | August 20, 2012 04:31 |
| Multiple domain interfaces on a single surface | mike | CFX | 2 | January 26, 2009 17:03 |
Threaded Mode
