|
[Sponsors] |
May 22, 2018, 12:12 |
High Mach Number Flow wiith Free Surface
|
#1 |
New Member
Join Date: Oct 2017
Posts: 18
Rep Power: 9 |
Is there any chance high Mach number flow option will be available with free surface feature within SolidWorks Flow Simulation?
|
|
June 27, 2018, 11:21 |
|
#2 |
Disabled
Join Date: Jul 2009
Posts: 616
Rep Power: 24 |
Probably not in the near future as it runs on the same "incompressible" solver and therefore the air flow should be below Mach 0.3 ideally.
Regards, Boris |
|
Tags |
high mach number, mach number, vof method, volume of fluid |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] snappyHexMesh sticking point | natty_king | OpenFOAM Meshing & Mesh Conversion | 11 | February 20, 2024 10:12 |
[OpenFOAM.org] OF2.3.1 + OS13.2 - Trying to use the dummy Pstream library | aylalisa | OpenFOAM Installation | 23 | June 15, 2015 15:49 |
DecomposePar unequal number of shared faces | maka | OpenFOAM Pre-Processing | 6 | August 12, 2010 10:01 |
Multiphase flow. Dispersed and free surface model | Luis | CFX | 8 | May 29, 2007 19:13 |
LES and high Mach number flow | Sachin | FLUENT | 0 | August 27, 2004 07:00 |