|
[Sponsors] |
February 25, 2013, 00:59 |
important: spillway with aerator device
|
#1 |
Senior Member
FHydro
Join Date: Jan 2013
Posts: 197
Rep Power: 13 |
Hello.
I have very important question. I have to simulate a spillway with aerator device, in Flow 3D.(for prevention of cavitation) Can flow 3D simulate this chute with artificial injection air into the ramp? or the ramp (eg. offset,groove or ...) is Sufficient for prevention of cavitation?(without injection air into the ramp) see this pic Last edited by flow_CH; February 25, 2013 at 07:26. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Spillway Analysis Fixed Water Surface Boundary Condition | mgdenno | OpenFOAM Running, Solving & CFD | 17 | December 9, 2018 17:37 |
Materials / Tutorials for simulating flow over spillway | basud0817 | FLOW-3D | 4 | August 25, 2015 04:39 |
Which hardwares for workstation are more important to do CFD analysis? | caitoc | Hardware | 9 | January 8, 2013 19:31 |
Calculating flow rate through a section of a spillway | Indus | FLOW-3D | 1 | November 5, 2012 18:54 |
Flow Over a Spillway | Nicopep | OpenFOAM | 1 | October 21, 2009 04:48 |