|
[Sponsors] |
December 2, 2021, 12:09 |
Resume a stopped simulation
|
#1 |
New Member
Bruno Rodrigues
Join Date: Nov 2021
Posts: 2
Rep Power: 0 |
Hello everyone,
I am pretty new to Flow-3D and I am running a stepped channel simulation. Unfortunately my computer crashed when I was trying to analyze some preliminary results while the solver was on 47%. When I reopened Flow-3D, it shows that the solver is "Simulating": However, there is nothing in my queue; the solver elapsed time is frozen; and the queue summary says that is nothing running. Because I have been running the simulation for little less than two hours, I am afraid to restart the simulation from scratch. When I click on "Run simulation" > "Local", it says that the results file already exists, and it prompts me to either rename it, overwrite it or abort. How do I resume the simulation (add it on the queue again and resume it) without overwriting it? Thank you in advance for any guidance. |
|
Tags |
restart problem, simulating |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transient simulation gives worse results than steady state simulation | jgross | CFX | 12 | January 21, 2021 12:21 |
How to pause a transient simulation and resume without time step advancement? | aleisia | Main CFD Forum | 33 | June 12, 2017 11:41 |
Fatal signal stopped the DPM simulation | Saidul | Fluent UDF and Scheme Programming | 2 | January 29, 2015 23:11 |
continue LES simulation after it stopped | holand_us | OpenFOAM | 9 | April 5, 2010 12:52 |
continue LES simulation after it stopped | holand_us | OpenFOAM Running, Solving & CFD | 1 | March 29, 2010 03:50 |