Pressure instability -- CFD Online Discussion Forums

February 18, 2022, 00:26	Pressure instability	#1
Andrea-wwwwwwww New Member Wenyu Zhao Join Date: Apr 2021 Posts: 18 Rep Power: 5	Hello everyone, I'm using FLOW3D to carry out the water entry test of the structure. The structure is set as a moving object, the coupling mode is turned on, and the measuring points are set on the structure to measure the pressure, but there will be many burrs in the obtained pressure, and the pressure measurement is very unstable. Do you have any good methods to deal with it?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
viscosity udf don't use correct temperature and strain rate	rezvani	Fluent UDF and Scheme Programming	8	May 27, 2021 05:40
Fail to converge when solving with a fabricated solution	zizhou	FLUENT	0	March 22, 2021 06:33
Wind tunnel Boundary Conditions in Fluent	metmet	FLUENT	6	October 30, 2019 12:23
Getting divergence while increasing the back pressure at pressure outlet	greenfields15	FLUENT	0	March 18, 2018 23:39
Periodic flow using Cyclic - comparison with Fluent	nusivares	OpenFOAM Running, Solving & CFD	30	December 12, 2017 05:35

All times are GMT -4. The time now is 16:39.