 |
 |
 |
|
|
|
[Sponsors] | ||||
April 30, 2024, 03:11
|
simulation
|
#1 |
|
New Member
Erfan Soltani
Join Date: Mar 2024
Posts: 17
Rep Power: 3  |
I am modeling, the height of the inlet flow is 0.12 cm and after that the height of the flow becomes more than 0.12 cm, I get a special pressure with a height of 0.12 cm at the outlet, it causes an error in the modeling. What should I do to keep the flow height constant?
Thank |
|
|
|
|
|
May 29, 2024, 05:23
|
|
#2 |
|
Member
Join Date: Jun 2014
Location: Turkey
Posts: 59
Rep Power: 13 |
What is the max z of your mesh block? It should be bigger that 0.1. Did you use time dependent fluid elevation table at your inlet BC?
|
|
|
|
|
|
|
May 29, 2024, 08:29
|
|
#3 |
|
New Member
Erfan Soltani
Join Date: Mar 2024
Posts: 17
Rep Power: 3 |
Thanks
max z is symmetry and mesh height 0.21 m I didn't use |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Convergence Problem - Transient Simulation | gemxx | Main CFD Forum | 0 | July 15, 2018 10:36 |
| Mapping Field Data for Mesh Regions from Another Simulation | veterator | OpenFOAM Pre-Processing | 1 | July 10, 2018 06:28 |
| Surface Source - Fixed Temperature? | robtheslob | FloEFD, FloWorks & FloTHERM | 18 | May 12, 2017 03:28 |
| Simulation FPEs - turbulence for transient and steady-state? | DaveR | OpenFOAM Running, Solving & CFD | 5 | March 5, 2017 16:06 |
| setting up a simulation with multiple interactions | phandy | OpenFOAM Running, Solving & CFD | 1 | October 6, 2014 04:16 |
Linear Mode
