 |
 |
 |
|
|
|
[Sponsors] | ||||
June 3, 2010, 13:07
|
cylindrical mesh
|
#1 |
|
New Member
Han
Join Date: May 2010
Posts: 13
Rep Power: 16  |
Hi,
When I use the cylindrical mesh, I set Y direction from 0-360, but it seems that there is a gap at the location of 0/360 degree, which can found in the attached figure after used FAVOR render. In fact the result also show there is a gap. How can resolve this problem? |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] vtk mesh or Abaqus mesh to OpenFOAM | bigphil | OpenFOAM Meshing & Mesh Conversion | 27 | November 23, 2015 17:31 |
| [Salome] unv mesh corrupted after createPatch | maddalena | OpenFOAM Meshing & Mesh Conversion | 1 | February 18, 2010 07:43 |
| [snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |
| Define mesh motion in cylindrical CS | rikio | CFX | 0 | June 3, 2009 22:21 |
| basic of mesh refinement | arya | CFX | 4 | June 19, 2007 12:21 |
Threaded Mode
