|
[Sponsors] |
April 18, 2017, 01:36 |
Unrecognized error
|
#1 |
New Member
Patel Brijesh
Join Date: Nov 2016
Posts: 8
Rep Power: 9 |
My project on shell and tube type condenser. In simularion choose Eulerian two phase model with k-e turbulent model. For cold water inlet give mass flow rate inlet condition and pressure outlet. Hot fluid also give mass flow inlet and pressure outlet condition. Here in condenser inlet and inside vacuum pressure so , at inlet given initial gauge pressure given -91000pa and outlet gauge pressure given -95000pa.
When I start Simulation (steady state), happens this :<br /> <br /> First error :<br /> Error: Cortex received a fatal signal (unrecognized signal). Error Object: () Then start the simulation again without problems, but throw this message previously: Error: cx-enable-item: wta[1](Widget) Error Object: #f Finaly , when the calculation finish without problems, or when I stop it, second Error: Error: cx-show-item: wta[1](Widget) Error Object: # Please give some suggestion..thank you. Sent from my Lenovo A7020a48 using CFD Online Forum mobile app |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM.org] compile error in dynamicMesh and thermophysicalModels libraries | NickG | OpenFOAM Installation | 3 | December 30, 2019 00:21 |
[OpenFOAM] Native ParaView Reader Bugs | tj22 | ParaView | 270 | January 4, 2016 11:39 |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
OpenFOAM without MPI | kokizzu | OpenFOAM Installation | 4 | May 26, 2014 09:17 |
DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |