|
[Sponsors] |
October 5, 2017, 07:18 |
DPM cone injection Problem
|
#1 |
New Member
Chris
Join Date: Jul 2017
Location: Hampshire, UK
Posts: 3
Rep Power: 8 |
Hi Everyone,
I'm having difficulty simulating a cone injection, settings seen in photo. I cant seem to simulate the spray properly using injection cone, i just get a doughnut. When i use surface injection there's no problem. Can anyone advise? Thanks ATTACH]58826[/ATTACH] |
|
Tags |
dpm, fluent, injection, multiphase |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with DPM simulation with particles injection and EXECUTE_AT_THE_END UDF. | Ari | Fluent UDF and Scheme Programming | 4 | May 31, 2016 08:51 |
DPM mass problem | Henrik Ström | FLUENT | 9 | May 20, 2016 11:00 |
Injection of water droplets using DPM | Mona | FLUENT | 6 | March 13, 2013 00:12 |
DPM injection mass flow rate | kingpots | ANSYS | 0 | November 22, 2012 11:12 |
Definition of swirl fraction for hollow cone injection in Fluent | launchpad | FLUENT | 0 | June 30, 2011 03:22 |