|
[Sponsors] |
December 13, 2018, 01:49 |
Outlet for only one phase?
|
#1 |
New Member
Join Date: Nov 2018
Posts: 3
Rep Power: 7 |
Can anyone help me...even Ansys Support canīt give me a satisfactorily answer
I have an two-phase (oil and air) flow in a porous medium. The porous media is a filter where the flow is from inside to outside. The outside is an outlet for both phases (pressure outlet). Now I want that the bottom of the filter is an outlet only for the oil phase. Is there a way to handle this, like a permeable wall or pressure outlet only for oil? A velocity outlet with or mass flow outlet with only oil isnīt a possibility because so I have to set the outflow of the drainage and the outflow should adjust dependent on the oil saturation in the filter. It would be stunning if anyone has an idea to solve this task. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Discrete Phase Model, outlet mass flow rate does not fit | edu_aero | FLUENT | 29 | February 3, 2020 08:38 |
Strange Results at Tank Outlet with InterFoam | mgdenno | OpenFOAM | 18 | November 28, 2019 23:05 |
Compressible flow, no data at the outlet | mireis | FLUENT | 6 | September 3, 2015 02:10 |
[swak4Foam] mass conservation of solid phase violated when using groovyBC with twoPhaseEulerFoam | xpqiu | OpenFOAM Community Contributions | 8 | June 17, 2015 02:08 |
one phase outlet VOF - Model | Jim87 | FLUENT | 6 | November 13, 2013 02:15 |