|
[Sponsors] |
January 23, 2020, 14:13 |
Open channelflow
|
#1 |
New Member
Sankar anand
Join Date: Jan 2020
Posts: 3
Rep Power: 6 |
I want to simulate a multipahse model of openchannel flow with air and water in 2d i am getting results. but,when i do the same in 3d i am getting error AMG solver divergence detected for all the 3 d models even very simple problems .
I draw my channel in ws and extruded it and using cut material i removed the hump portion inside the channel and then meshed and getting error |
|
January 23, 2020, 21:23 |
|
#2 |
Senior Member
Svetlana Tkachenko
Join Date: Oct 2013
Location: Australia, Sydney
Posts: 407
Rep Power: 14 |
Does the 3D model work in single phase?
Could you please attach a screenshot of your 2D and 3D geometry and mesh? Thanks |
|
January 26, 2020, 03:57 |
|
#3 |
New Member
Sankar anand
Join Date: Jan 2020
Posts: 3
Rep Power: 6 |
No it can't be done in 2D case but other 2 D cases are running well mine is 3D
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] Installation Problem with OF 6 version | Aurel | OpenFOAM Community Contributions | 14 | November 18, 2020 16:18 |
[swak4Foam] groovyBC in openFOAM-2.0 for parabolic velocity bc | ofslcm | OpenFOAM Community Contributions | 25 | March 6, 2017 10:03 |
[swak4Foam] swak4foam building problem | GGerber | OpenFOAM Community Contributions | 54 | April 24, 2015 16:02 |
[swak4Foam] Swak4FOAM 0.2.3 / OF2.2.x installation error | FerdiFuchs | OpenFOAM Community Contributions | 27 | April 16, 2014 15:14 |
friction forces icoFoam | ofslcm | OpenFOAM | 3 | April 7, 2012 10:57 |